Work Instructions: Bay Wash Cat Pump Oil Change
Preliminary Instruction:
- Oil should be changed after 8,000 initial cars (50hrs). After that, oil should be changed every three months or 80,000 cars (500hrs), whichever comes first.
Parts Needed:
- Cat Pump Oil (P-SE-PG-220) https://shop.tommycarwash.com/Cat-Pump-Oil-6100
Tools Needed:
- Safety glasses
- Adjustable wrench
- Oil Drain Pan
- Funnel (if wanted)
Procedure:
- Turn the power off to the Bay wash pump. Place a Lock-out Tag-out on the disconnect.
- Turn the bay wash pump on Tommy Controller to “OFF”.
- Line up the oil drain pan with the oil drain shaft to the bay wash pump.
- Take the plug off of the ball valve on the oil drain on the bay wash pump.
- Turn the ball valve to the open position so oil flows out of the drain.
- Take the red cap off of the top of the bay wash pump to the oil fill port.
- Once the oil is drained completely, put the plug back into the ball valve and turn the ball valve back to the closed position.
- Put a funnel in the oil fill port to fill the bay wash pump with oil until the oil level reaches just over the middle of the sight glass.
- Once full put the red cap back on to the oil fill port. Only hand tighten it as It is a plastic cap and can break if overtightened.
- Remove Lock-out Tag-out from Bay was pump disconnect in M.C.C.
- Turn the Bay wash pump back to “Auto” on Tommy Controller.
- Recycle the old oil.
Instructional Video: